Pull a wire galley-to-cabin?

JLH
JLH Member Posts: 21
in Modifications & Upgrades

What's my easiest way to pull a cable from the galley into the cabin? I could drill a small hole through the bottom/rear of the cabinet where the cooler sits, but then I'd need one in the cabin wall, too. Is there a better way, super-clever-t@ggers?

· Share on Facebook

Comments

  • JamesDow
    JamesDow Member Posts: 751

    I have a 2018 standard 5-wide.

    I pulled wires from behind my refrigerator (existing wall plate). Other easy option, revove galley electrical/12 volt cover and pull from that point.

    · Share on Facebook
  • JLH
    JLH Member Posts: 21

    Electrical cover. Of course. Thank you!

    · Share on Facebook
  • The_Rigger
    The_Rigger Member Posts: 204
    edited January 2024

    If you remove the stereo receiver from the interior wall (and once you pop the bezel off it's only four screws), it's almost a straight shot to the back of the right-hand-side electrical outlets in the galley. Creative use of a fish tape will get you there.

    The hardest part is rounding up a #2 Robertson screwdriver to work with the square-drive screws.

    Dave in Michigan
    '21 T@G XL
    "If you don't know where you're going, any road will take you there." ~ The Cheshire Cat (Alice in Wonderland)

    · Share on Facebook
  • Jay
    Jay Member Posts: 76
    edited January 2024

    Every Canadian has at least 2 of each, a red and green handled Robertson screw driver
    in their tool box..:) The trailer is full of them, best to buy one.

    · Share on Facebook
  • JLH
    JLH Member Posts: 21

    Thanks, all!

    · Share on Facebook

Categories