2024 T@G black exterior handles

VTTAG

While moving our new t@g on flat surface one of the exterior moving handle pulled out of the housing. I tried screwing it back in but the location where the screw was is now stripped and won't tighten. 
Is there a fix for this anyone might have encountered? 
Maybe a larger screw? 

Thank you 

robteroy

Hi there. I would fill the hole with an epoxy wood filler from JB weld or Gorilla glue.  Pre drill a smaller hole for the same screw.

We’ve found with our T@G those handles are week for steering sideway so we steer with the tongue and pull/push forward and back with the handles. 

VTTAG

Thank you so much! Sounds like a good idea. Yes, its too bad the handles are not more useful. 

robteroy

👍

VTTAG

Thank you for the suggestion, we cleaned up the area, filled with some gorilla glue as you suggested and some small toothpick sized wood slivers and reinstalled (with weather proof caulking. Handle seems stronger now then the factory side. We were thinking of just removing them completely.    

danp

Golf tees work great for this 

VTTAG

I will have to pick some up for the other handle:)