Best Of

Just pick up our new 2021 TAG Boondock XL this weekend. The dealer walk-through was rather brief, so I have been spending some time going through the systems and verifying that all work as expected. Last evening I was testing out the Nashone wireless remote thermostat for the Crane heater. After warming up the inside, I set the thermostat to a temp below the interior temp showing on the thermostat. I expected thermostat to shut off, but it kept cranking away. So, my guess is that it is not properly paired with the Nashone receiver plug that the heater is plugged into. However, I can't find the outlet where heater is plugged in (guessing it is behind the cabinets).

Does anyone know where the heater is plugged in and how to access it?

Cheers!

Paul

Thank you for all the help. The dealership didn't put a rubber gasket on the end of the hose so it was sucking in air. I popped a gasket in and it works great!

Here is a video about adjusting the pump:  https://youtu.be/DdH2Pf-UllA?si=JhaKCkXguEALVgQS

Manual:  https://www.pentair.com/content/dam/extranet/web/nam/shurflo/manuals/911-1008-4008-rv-by-pass-pump-iom.pdf

If the pump you put in is good, remove it from the trailer connect a hose to the suction side and put that in a bucket of water if, when powered it pumps water you have a good pump. That would mean you must a have valve that has failed closed, a blockage, or a big air leak. As mentioned earlier you could just undue the hoe clamp on the discharge side and see what happens. Then check all the other hoses, take pictures so you know how it all goes back together.